Commissioning and maintenance of your
SDMO® NEO Inverter portable generating set

SDMO® designs generating sets, which comply with the strictest quality and safety standards.
Here is some useful information on making the best use of your generating set.

To find our demonstrations
go to "Need help?" at
www.sdmo.com

Commissioning

manualtankdo_not_tiltsuppressor
  • Always refer to the generating
    set user manual.     There you will
    find all the required information,
    such as the correct procedure
    for commissioning your
    NEO Inverter generating set.
  • Fill the tank with 15W40 oil
    (oil can offered as an option).

  • Important, the generating set
    must be positioned on a
    flat surface.

  • After waiting a short while,
    check     the oil level using
    the gauge.

  • Do not exceed the maximum
    oil level     on refilling.
  • Do not tilt the generating set
    when refilling the oil tank.

  • Use clean, fresh, unleaded
    fuel.

  • Do not store fuel for more
    than one month.

  • Store the fuel in a clean
    hydrocarbon can     which has
    been manufactured for
    this purpose    .
  • Check the suppressor is
    correctly connected.

  • Open the petrol tap.

Safety instructions

manualnot_use_in_presence_childrenclose_the_petrol_tapOperate
  • Each time before starting
    your NEO Inverter generating
    set, carefully read
    the commissioning manual
    to familiarise yourself with
    the equipment’s operating
    controls    .
  • Do not use your portable
    generating set     in the presence
    of children, uninformed people
    or animals.

  • It is strongly advised to avoid
    using     your generating set after
    consuming substances     likely
    to adversely affect your physical
    abilities.
  • Do not exceed the maximum
    oil level     on refilling.

  • Make sure that you tightly
    close the petrol tap before
    transporting     your SDMO®
    NEO Inverter generating set.
  • It is important to operate
    your NEO Inverter generating
    set in the open air,
    outside a building.

  • In the event of indoor use,
    exhaust gases MUST be
    directed outside    , and ensure
    that ventilation is sufficient
    to avoid affecting people
    within the building.

Regular maintenance

periodic_inspectionsair_filternot_spray_with_water
  • Before any intervention,
    disconnect spark plug
    suppressor     and check
    oil level     on the graduated
    gauge    .
  • Check air filter condition,
    clean or replace
    where necessary.

  • Check the cleanliness
    of the alternator ventilation
    vents     to ensure that adequate
    cooling is maintained.
  • Important, do not spray
    the engine or alternator of your
    NEO Inverter generating set
    with water.

Maintenance before winter storage: at the end of the season a number of points must be checked...

grease_all_moving_partsdrain_engine_oilsparkcleanliness_of_alternator_ventilation_vents
  • Carefully clean all exterior
    parts     of your generating set.

  • Do not spray the engine or
    alternator of your generating
    set with water.

  • Grease all moving parts.
  • Run engine until petrol
    runs out to avoid deposits    .

  • Drain engine oil then refill
    with new oil.
  • Unscrew spark plug.

  • Pour 3cm3 of oil into
    the spark plug opening.

  • Turn over the engine
    2 or 3 times via the starter
    to distribute the oil    .
  • Check condition of air filter
    and replace where necessary.

  • Check cleanliness of
    alternator ventilation vents
    to ensure adequate cooling
    is maintained    .